Level 2 Sprint 3 Create Combination Chart for Dashboard

[kunal_311]

Hi Team,

Before you publish the SYS01 Time Settings by Month module, showing the Planning Period Filter line item, filter it to show months only and save the view as Filter for Product Replenishment Dashboard.

This is the requirement of the course. I applied the filter on months only & saved it as "Product replenishment DB" but when I published my line item of "Planning Period Filter" from system time settings month module to my DB then I am not getting the result as attached image(FILTER 2) Instead my result is showing as attached image(FILTER 1)

These are the following steps I performed to complete the instructions, Is there something I am doing wrong/misinterpreting?

[JussiLi]

Hi@kunal_311,

Try different publish method. Read the instructions carefully.

Regards,

JussiLi

[kunal_311]

Hi@JussiLi

I opted for show selection option and publish it as shown in "Chart 01".

Which is different from what was given in course content "Chart 02".

@einas.ibrahim

@Misbah

[JussiLi]

Hi@kunal_311,

In my opinion "Chart 01" is correct in terms of publish method. You just need to adjust its dashboard setting so that all months are available for selection, not just Jan-Jun 20.

Regards,
JussiLi

[kunal_311]

Hi@JussiLi

The DB setting is adjusted as shown in the image.

But my question was my chart view and the view in the course which we are referencing as "chart 02" is different. So wanted to know is I am doing something wrong?

[JussiLi · Accepted solution]

@kunal_311,

The chart looks like yours, if no purchase order requests have been made. If you select same 'Submit Purchase Order Requests' as in the sprint example (see pic below), your chart should be similar.

Regards,

Jussi